Mobrey

Parameter Description Min. Max. DefaultNo. value value Ex-FactoryD750 Model Code Hart parameter - - -D751 Serial Number - Control Unit - - -Store as Final Assembly Number (FAN)D752 Hardware Revision - - -Factory-setD753 Software Revision - - -Factory-set, embedded in softwareD760 Manufacturer’s Code - - -Factory set not atlerableD761 Unique ID - - -Hart parameterD762 Universal Command Revision - - -Hart parameterD763 Transmitter Specific Command Revision - - -Hart parameterD764 Preamble Bytes - - -Hart parameterD765 Flags Hart parameter - - -D800 PV - - -D801 Sludge Density - - -D805 % Current Output - - -D806 Current output Current is proportional to PV - - -D810 Totaliser Value - - -D820 Relay Status - - -D821 Relay 1 Run-Time Resettable - Hours & Minutes - - -D822 Relay 2 Run-Time Resettable - Hours & Minutes - - -D830 Alarm report e.g. Sensor Fault, …. - - -D835 Digital input status - - -D841 Current inputValue of current input (mA) - - -D844 TemperatureThe temperature o C within the control unit - - -D850 Attenuation @ 1MHz Attenuation - - -D851 Attenuation @ 3.3MHz Attenuation - - -D852 Attenuation unsmoothed - - -D853 Signal level (Raw A/D bits)Raw RF A/D output - - -D854 Span Average @ 1MHz (dB)Diagnostic parameter that averages the span calibrations - - -D855 Span Average @ 3.3MHzDiagnostic parameter that averages the span calibrations - - -D858 Slope 1The value of the attenuation in dB/% @ 1MHZdetermined by the control unit. - - -D859 Slope 3The value of the attenuation in dB/% @ 3.3MHZdetermined by the control unit. - - -D860 Frequency of operationDiagnostic of frequency(ies) being used (MHz) - - -D861 Maximum densityThe maximum density that can be measured.This value is calculated from zero and span data. - - -37IP258