NOTICE

SECTION 8 CESSNA
HANDLING, SERVICE, AND MAINTENANCE MODEL 208B G1000
GROUND DEICE/ANTI-ICE OPERATIONS (Continued)
The procedure involves applying Type II, Type III, or type IV anti-ice
fluid to make sure the airplane remains clean after deicing. Type II,
Type III, or Type IV fluid is used to provide longer-term anti-icing
protection. Type I, Type II, Type III, and Type IV fluids have time
limitation before refreezing begins, at which time additional deicing is
required. This time limitation is referred to as “holdover time”. Because
holdover time depends highly on a number of factors, charts can
provide only approximate estimates. It remains the responsibility of the
pilot-in-command to determine the effectiveness of any deicing or antiicing
procedure. Refer to FAA notice 8900.22, dated 10-12-07 or later
for Type I, Type II, Type III or Type IV fluids.
8-26
U.S.
CAUTION
Type I, Type II, Type III, and Type IV fluids are not
compatible and may not be mixed. Additionally, most
manufacturers prohibit the mixing of brands within a
type. However, the same spray equipment may apply
Type I and Type III fluids. Line personnel should be
supervised by the pilot in command to ensure proper
application of Type I deice, and Type II, Type III, or
Type IV anti-ice fluids.
NOTE
Deicing fluids are not intended for use in removing snow
deposits. Snow is best removed by mechanically sweeping
or brushing it from the airplane structure. Use caution not to
damage any airplane structure or antennas when removing
snow.
(Continued Next Page)
208BPHBUS-00