ES721 ISO40 7 kW NL - HSD

HSD
10.10 CHOICE OF TOOLHOLDER CONE
� The geometry of the ISO conicity must conform to DIN69871 standard (see Image 10-2),
for the special version follow the product specifications (see Image 10-3);
� Avoid the presence of plugs, slots, or other forms affecting the dynamic balancing of the
tool holder
� The degree of dynamic balancing must be G = 2.5 or better (standard ISO1940);
� Balancing is performed with the tool holder assembled (cone, mill collet, ring nut, tool).
63
O
12
O
CONO/CONE ISO 40
ISO/DIS 7388/1
DIN 69871
30°
O 6.35
Image 10-2 – ISO 40 Standard
49.3
35
M 16
15°
O 6.35
Image 10-3 – ISO 40 Special
Codolo/Pull Stud
standard HSD
code: H080706700
The pull stud (also referred to as retention knob) must be HSD article code
H080706700.
It is strictly forbidden to install pull studs of any type other than the HSD typeapproved
article specified above. Failure to comply can lead to breakage or
ineffective locking of the toolholder and EXTREMELY SERIOUS RISKS FOR
THE OPERATOR.
When cleaning the cone, make sure that the pull stud is screwed firmly into
the toolholder.
5801H0066 en Rev.01 31/48
61
44
O
Codolo/Pull Stud
standard HSD
code: H080706700