ES721 ISO40 7 kW NL - HSD

More documents

Recommendations

Info

HSD 11.2 BIWEEKLY MAINTENANCE 11.2.1 Clean the tool holder cone with ethyl alcohol Carefully clean the contact surfaces of the tool holders (shown in Image 11-1 and Image 11-2) with a soft, clean cloth dipped in ethyl alcohol. 5801H0066 en Rev.01 36/48
HSD § 12 REPLACEMENT OF COMPONENTS Inside the electrospindle, there is a pre-loaded spring with a force of hundreds of kilograms. This spring is attached to a tie-rod that may be thrown out violently if the electrospindle is dismantled by personnel who have not been sufficiently trained. Carry out only the operations described in this manual, paying close attention to the instructions given; for further information, contact HSD S.p.A. Customer Service. Observe the safety precautions for maintenance given on page Errore. Il segnalibro non è definito.. Only the adjustment and replacement operations with original HSD S.p.A. spare parts described in this section of the manual are permitted. Any other type of operation is not permitted and will invalidate the product warranty. 5801H0066 en Rev.01 37/48
Page 1 and 2: HSD MECHATRONIC D I V I S I O N HSD
Page 3 and 4: HSD 10.7.2 Electrospindle states an
Page 5 and 6: HSD § 4 TERMS OF WARRANTY HSD S.p.
Page 7 and 8: HSD 5.3 RISKS ASSOCIATED WITH THE E
Page 9 and 10: HSD § 6 TRANSPORT, PACKAGING, UNPA
Page 11 and 12: HSD § 7 TECHNICAL SPECIFICATIONS 7
Page 13 and 14: HSD § 8 DIMENSIONS AND MAIN PARTS
Page 15 and 16: HSD 8.1.2 Direct liquid coolant cou
Page 17 and 18: HSD 8.1.3 Deublin distributor, enco
Page 19 and 20: HSD § 9 INSTALLAZIONE HSD S.p.a. d
Page 21 and 22: HSD DPC 5801H0066 en Rev.01 21/48 !
Page 23 and 24: HSD 9.7 COMPRESSED AIR SPECIFICATIO
Page 25 and 26: HSD 9.10 AUTOMATIC CONE CLEANING 1.
Page 27 and 28: HSD § 10 OPERATION 10.1 GENERAL PR
Page 29 and 30: HSD 10.7.2 Electrospindle states an
Page 31 and 32: HSD 10.10 CHOICE OF TOOLHOLDER CONE
Page 33 and 34: HSD 1 2 3 4 5 6 UTENSILE BLOCCATO U
Page 35: HSD 11.1 DAILY MAINTENANCE 11.1.1 C
Page 39 and 40: HSD 12.1.2 Replacement and adjustme
Page 41 and 42: HSD 12.1.5 Sensor S5 adjustment Aft
Page 43 and 44: HSD § 14 LIST OF SPARE PARTS CODE
Page 45 and 46: HSD The tool holder is not locked:
Page 47 and 48: HSD § 16 DECLARATION OF INCORPORAT

ES721 ISO40 7 kW NL - HSD

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?