ES721 ISO40 7 kW NL - HSD

HSD
The electrospindle
overheats:
Performance below
specifications:
The electrospindle
vibrates:
The bearings are noisy:
Cooling problems:
The machining is taking up too
much power
The inverter setup is incorrect
The inverter setup is incorrect
The tool holder is not balanced
The tool is not balanced
There is dirt or foreign bodies
between the tool holder and the
spindle shaft housing
The inverter setup is incorrect
The machining is taking up too
much power
� Check cooling circuit
specifications in section 9.4 ;
� Check the cooling system for
leaks and losses or clogging.
� Contact the HSD Technical
Assistance Service.
Reduce the machining power
requirements.
Check the specifications of the
electrospindle on its data label
and in paragraph 7.1 .
Check the specifications of the
electrospindle on its data label
and in paragraph 7.1 .
Choose a tool holder in
accordance with paragraph § 10.
Choose a tool in accordance with
paragraph § 10.
Remove any large foreign bodies
and clean the tool holder cone
and spindle housing as instructed
in section § 11.
Check the specifications of the
electrospindle on its data label
and in paragraph 7.1 .
Reduce the machining power
requirements.
The fixing bolts are loose Tighten the fixing bolts.
The bearings are worn or Contact the HSD technical
damaged
assistance service.
The bearings are worn or Contact the HSD technical
damaged
assistance service.
5801H0066 en Rev.01 46/48