Genisys User Guide - OTC

DLC Cables
The DLC cable connects the scan tool to the vehicle’s
data link connector (DLC). The cable used
depends on the type of vehicle being tested. The two
most common cables are shown below. An optional
extension cable may also be used.
NOTE: The scan tool software tells you which cable must
be used for the vehicle you are testing. For details, refer
to Step 1: Enter the Vehicle Information on page 14.
System Smart 25-Pin Cable (3305-73)
The System Smart 25-pin cable is for On Board
Diagnostic II (OBD II) vehicles.
Figure 1.12: System Smart 25-Pin Cable
DB25 Power Cable (3305-72)
The DB25 power cable is for non-OBD ll vehicles
and some OBD II vehicles.
Figure 1.13: DB25 Power Cable
1: General Information
Component Descriptions
Add-On Hardware Modules (optional)
When you purchase the Cartridge Reader, InfoTech /
Scope, or Gas M-P software applications, you receive an
add-on hardware module that connects to the back of the
scan tool.
NOTE: For purchasing details, contact your local tool
distributor.
Figure 1.14: Cartridge Reader Module
Figure 1.15: Gas M-P Module and Exhaust Test Probe
Figure 1.16: Scope Module and Test Probes
Scan Tool User Guide 5