air data test set mps 30 digital portable user manual - CALIBRATION ...

MPS 30 User’s Manual DMMC/0803/CM
• The numeric keys (0–9/F0–9) to set the desired values of the controlled
parameters when used with RED or BLUE SHIFT functions, F0–F9.
(Note: Some of the “F” legends on the upper position of the numeric keys
are not used and can be programmed for custom requirements.)
• The UP triangle key (▲) to increase, by a pre-programmed step, the
different parameters (AL, AS, and AR).
• The DOWN triangle key (▼) to decrease, by a pre-programmed step, the
different parameters (AL, AS, and AR).
• The PROG/EXEC/DEFAULT key for programming functions. PROGram is
used for entering the programming mode, EXECute to initiate the
program, and DEFAULT for returning to the operational mode.
• The AL, AS, AR (UP/DOWN ARROW) key is used before the previous
key to establish the parameter that must be changed.
• The BLUE SHIFT key ( ) to activate the upper-left functions on the keys,
marked in blue.
• The RED SHIFT key ( ) to activate the upper-right functions on the keys,
marked in red.
• The GO/ENTER key (↵) to input the desired data to the MPS 30.
• The EPR/NOR key to generate a total pressure/static pressure ratio
starting from the desired altitude. The blue upper-left NOR on this key is
used to reset the NORmal air data operation, when used with BLUE
SHIFT.
Issue Aug. 03 D. Marchiori PROPRIETARY INFORMATION - 16
This material not to be disclosed or reproduced.