air data test set mps 30 digital portable user manual - CALIBRATION ...

MPS 30 User’s Manual DMMC/0803/CM
NOTE 2
The Airspeed is set up to 100 Kts. for every
test point because the test is related to the
static system. Also ZERO Kts could be set
up for the Airspeed (except points A and B
of TABLE 2). If the Airspeed indicator must
be checked, different Airspeed data can be
commanded. The airspeed instrument is
better tested leaving the aircraft or the
instrument static port in ambient (thus
leaving in ambient also the MPS30 static
port and setting its AR = 0, this removes the
control of the static pressure)
step Alt Asp Rate Rate Wait L0 L1
A 500 100 0 300 0 60 30
B 5000 100 3000 300 0 60 30
C -1000 100 3000 300 90 0 0
D 0 100 3000 300 90 0 0
E 500 100 3000 300 90 0 0
F 1000 100 3000 300 90 0 0
G 1500 100 3000 300 90 0 0
H 2000 100 3000 300 90 0 0
I 3000 100 3000 300 90 0 0
J 4000 100 3000 300 90 0 0
K 6000 100 3000 300 90 0 0
L 8000 100 3000 300 90 0 0
M 10000 100 3000 300 90 0 0
N 12000 100 3000 300 90 0 0
O 14000 100 3000 300 90 0 0
P 16000 100 3000 300 90 0 0
Q 18000 100 3000 300 90 0 0
R 20000 100 3000 300 90 0 0
S 22000 100 3000 300 90 0 0
T 25000 100 3000 300 90 0 0
U 30000 100 3000 300 90 0 0
V 35000 100 3000 300 90 0 0
W 40000 100 3000 300 90 0 0
X 45000 100 3000 300 90 0 0
Y 50000 100 3000 300 90 0 0
TABLE 2
Issue Aug. 03 D. Marchiori PROPRIETARY INFORMATION - 38
This material not to be disclosed or reproduced.