air data test set mps 30 digital portable user manual - CALIBRATION ...

MPS 30 User’s Manual DMMC/0803/CM
The ">" symbol will now flash in front of Asp. value, insert the Airspeed to be
simulated at that point or confirm it by pressing " GO".
Continue inserting the Altitude rate and Airspeed Rate values.
Now the ">" symbol flashes in front of: "Wait".
The value to be entered corresponds to the time (in seconds) that the MPS30
will wait before passing automatically to the next step. If 0 (zero) value is entered,
the MPS30 will not pass to the next step unless the ▲ (up arrow) is pressed. (Note
that, also if a value is entered, it is always possible to pass to the next step by
pressing ▲ or to the previous one by pressing the ▼ keys).
After the wait time is set up, the ">" flashes in front of L0: this corresponds to the
stabilization time for the leak check (i.e. the time – in seconds to stabilize the
pressure before the leak is measured.). If zero value is inserted, the MPS30 will not
perform the stabilization time for the leak test.
When the stabilization time is set up, the ">" flashes in front of L1: this is the
measuring time for the leak test (i.e. the time in seconds to measure the leakage). If
Zero value is entered, the MPS30 will not perform the leakage measurement.
When the MPS30 is performing the leak test, the following menu appears:
READ
SET
PRESS
ALTITUDE AIRSPEED RATE
172 100.0 0
A. 500 100.0 0
LEAK WAIT 72 sec
Pr: 1 0.160 FAR43&LK
Pt/Ps MACH UNITS
READ
Issue Aug. 03 D. Marchiori PROPRIETARY INFORMATION - 32
This material not to be disclosed or reproduced.
SET
PRESS