D CDA3000 Inverter Drive System 750 W - 132 kW - Igor Chudov

2.3 Wall mounting
BG6
CDA3000 Operation Manual
2 Mechanical installation
Step Action Comment
1
2
3
4
Mark out the position of the tapped holes
on the backing plate.
Cut a tap for each fixing screw in the
backing plate.
Mount the inverter module vertically on
the backing plate.
Mount the other components, such as the
mains filter, line choke etc., on the
backing plate.
Continue with the electrical installation in
section 3.
F
;;; yyy;;
yy
F
UM-xxxx
Figure 2.1 Mounting clearances (see Table 2.2)
Note the following points:
E
CM-xxxx
E1
2-2
Dimensional drawings/hole
spacing see Table 2.2.
The tapping area will provide
you with good, full-area contact.
Pay attention to the mounting
clearances!
The contact surface must be
metallically bright.
Mains filter max. 20 cm below
the inverter module
;;; yyy ; y ; y;;
yy;
y
; y ; y ; y
; y ; y ; y
Air must be able to flow unhindered through the device.
For mounting in switch cabinets with convection (= heat loss is
discharged to the outside via the cabinet walls) an internal air
circulation fan must always be fitted.
The backing plate must be well grounded.
The best result for effective EMC installation is attained with a
chromated or galvanized backing plate. If backing plates are
varnished, the coating must be removed in the area of the contact
surface!
G