D CDA3000 Inverter Drive System 750 W - 132 kW - Igor Chudov

3.8 Control
connections
CDA3000 Operation Manual
3 Installation
Step Action Comment
1
2
Check whether your inverter module is
fitted
a modified software package
(>V100.x)
(standard software = Vx.xx-xx)
If this is the case, the control terminal
assignment is different. Please
contact your project engineer with
regard to wiring and commissioning!!
Check whether you already have a
SMARTCARD or a DRIVEMANAGER data
set with a complete device setup.
If this is the case, the control terminal
assignment is different. Please
contact your project engineer to obtain
the terminal assignment!
3 Choose a terminal assignment.
4
5
Wire the control terminals with
shielded cables.
The only essential signals are the
ENPO signals and a start signal
(STR or STL).
Keep all contacts open
(inputs inactive).
6 Check all connections again!
Note the following points:
3-13
ANTRIEBSTECHNIK
D- 35633 Lahnau
Position of software name plate see
section 3.1 Page 3-2
Bulk customers
Type: CDA32.004,C1.0
Software: V 1xx.x
CS:
Data Set:
C1D1
SN.: 99120442
For details of how to load the data
set into the inverter module refer to
section 4.6.
see 3.8.1 “Choice of terminal
assignment”
Ground the cable shields over a
wide area at both ends.
Wire cross-section maximum
1.5 mm² or two cores per terminal
each 0.5 mm²
Continue with commissioning in
section 4.
Always wire the control terminals with shielded cables.
Lay the control cables separately from the mains lead and motor
cable.
The CDA3000 Application Manual presents more drive solutions.
For all shielded connections a cable type with double copper
braiding with 60-70 % coverage must be used.
1
2
3
4
5
A
DE
EN
FR
IT
ES
FR