D CDA3000 Inverter Drive System 750 W - 132 kW - Igor Chudov

2.4 Cold plate
CDA3000 Operation Manual
2 Mechanical installation
Step Action Comment
1
2
3
4
5
Mark out the positions of the tapped
holes on the backing plate or the cooler.
Cut a tap for each fixing screw in the
backing plate.
Clean the contact surface and coat it
thinly and evenly with heat transfer
compound.
Mount the inverter module vertically on
the backing plate or cooler. Tighten all
screws to the same tightness.
Mount the other components, such as the
mains filter, line choke etc., on the
backing plate.
Continue with the electrical installation in
section 3.
F
E
;;; yyy;;
yy
F
UM-xxxx
Figure 2.2 Mounting clearances (see Table 2.3)
2-4
Dimensional drawings/hole
spacing see Table 2.3.
The tapping area will provide
you with good, full-area contact.
The contact surface must be
metallically bright.
Pay attention to the mounting
clearances! Size of cooling
surface see Table 2.4.
Mains filter max. 20 cm below
the inverter module
;;; yyy ; y ; y;;
yy;
y
; y ; y ; y
; y ; y ; y
CM-xxxx
E1
G