Tactics, techniques, and procedures for - Army Electronic ...
Tactics, techniques, and procedures for - Army Electronic ...
Tactics, techniques, and procedures for - Army Electronic ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
FM 42-414<br />
3-26<br />
CAUTION<br />
The exhaust duct becomes very hot when the shower unit is operating. To<br />
prevent severe burns, soldiers must not touch the duct while the equipment is<br />
in use.<br />
• Fuel connection setup. To connect the fuel set up, shower personnel per<strong>for</strong>m the following steps:<br />
•• Place the fuel container about 5 feet from the water heater.<br />
WARNING<br />
Fuel used with the shower unit is highly flammable <strong>and</strong> may be dangerous<br />
to human life if h<strong>and</strong>led improperly. All fuel fittings must be tightened<br />
firmly with a wrench to prevent leaks. Recheck all fittings when the water<br />
heater is operating to ensure no fuel leaks with the system under pressure.<br />
•• Screw the drum fill adapter into the fuel container.<br />
•• Connect the fuel line from the pump filter to the suction fitting on the drum fill<br />
adapter assembly.<br />
•• Connect the fuel line from the pump to the return fitting.<br />
•• Connect the cable assembly to the water heater, water pump, <strong>and</strong> power source.<br />
WARNING<br />
Use only specified fuel. Failure to do so may result in injury to personnel<br />
or equipment.<br />
CAUTION<br />
Lack of lubrication may cause pump damage when straight gasoline is used as<br />
fuel. To avoid failure, 1 quart of oil must be mixed with each 5 gallons of<br />
gasoline used.