Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke
Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke
Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Fuxx</strong> <strong>Control</strong> <strong>ARS</strong> <strong>2320</strong> / <strong>ARS</strong> <strong>2340</strong> KUHNKE Automation<br />
10.2 Operating mode and error messages<br />
10.2.1 Operating mode and error display<br />
The system supports a seven-segment display. The following table describes the display and the<br />
meaning of the symbols shown:<br />
Table 44: Operating mode and error display<br />
Display Meaning<br />
In this operating mode the outer bars “rotate”, depending on the speed resp. the position<br />
of the rotor.<br />
If the drive is enabled, the center bar of the seven-segment display is on.<br />
The servo positioning controller <strong>ARS</strong> 2000 is yet to be parameterised.<br />
(seven-segment display = A)<br />
Operating mode torque control, the two bars on the left hand of the display are on.<br />
(seven-segment display = I)<br />
P xxx Positioning, “xxx” stands for the position set number. The numbers are successively<br />
indicated.<br />
PH x Homing is active, „x“ stands for the active phase of the homing run.<br />
0 : Search phase<br />
1 : Crawling phase<br />
2 : Positioning to zero position<br />
The figures are successively indicated.<br />
E xxy Error message / number with index “xx” and subindex “y”<br />
-xxy- Warning message / number with Index „xx“ and subindex „y“. A warning is displayed at<br />
least twice on the seven-segment-display.<br />
Option „Safe Stop“ active for the <strong>ARS</strong> 2300 devices.<br />
(seven-segment display = H, blinking with a frequency of 2Hz)<br />
118 E 732 GB<br />
14.12.2006
Change language