Fuxx Control - ARS 2320 / ARS 2340 Instruction Manual - Kuhnke

Fuxx Control ARS 2320 / ARS 2340 KUHNKE Automation
The ARS 2300 servo positioning controller has one differential analog input (AIN0) and two singleended
analog inputs designed for input voltages in the range of ± 10V. Inputs AIN0 and #AIN0 are led
to the control system via twisted cables (twisted-pair type). If the control system has single-ended
outputs, the output is connected to AIN0 and #AIN0 is connected to the reference potential of the
control system. If the control system has differential outputs, they have to be connected 1:1 to the
differential inputs of the ARS 2300 servo positioning controller.
The reference potential AGND is connected to the reference potential of the control system. This is
necessary in order to prevent the differential input of the ARS 2300 servo positioning controller from
being overridden by high "common-mode interferences".
There are two analog monitor outputs with output voltages in the range of ± 10V and one output for a
reference voltage of +10V. These outputs can be led to the superimposed control system, the
reference AGND must be carried along. If the control system has differential inputs, the "+" input of the
control system is connected to the output of the ARS 2300 servo positioning controller and the "-"
input of the control system to AGND.
8.7.1 Configuration on the device [X1]
� D-SUB connector, 25-pin type, female
8.7.2 Mating connector [X1]
� D-SUB connector, 25-pin type, male
� Housing for 25-pin D-SUB connector with bolting screws of type 4/40 UNC
92 E 732 GB
14.12.2006