GV-LPR License Plate Recognition User Manual - GeoVision

Chapter 3 System Configuration
infrared is triggered, you may enable the [Sync Output] and set the [Pin Setup] for it. You may set the [Delay
before Trigger] if needed. The [Trigger Time] can be synchronized with the input or user-defined.
Figure 3-31
[Sync Application] You may enable it so that a program can be synchronized to run for integration.
[Select Application] You may select the Synchronized Application Path by clicking this button.
[Sync Application Path] The selected Sync Application Path will be shown.
[Output Setup]
Up to 8 outputs can be set according to the result of the recognition. Output Setup 1~ 8 are mainly for output
triggering by recognition result. Other programs can be synchronized to run for integration. Hot Key can be set
to trigger the outputs.
Figure 3-32
[Output Trigger Name] You may give a meaningful name to identify the trigger, for example, “Gate” or
“Light”.
35