GV-LPR License Plate Recognition User Manual - GeoVision

Chapter 3 System Configuration
6. Click the [Add] button to add a new counter. Click [Edit] after you have modified the settings of a counter.
You may manually input the path of [Export location Setup] or by clicking the [Set Location] button.
Note: If you are going to count the remaining unit of parking lot, you may set the [Initial Counter] to
current empty unit and select [Decrease Counter] to keep the counter function correctly.
3.2.5 Repeat Recognition Setting
[Repeat Recognition] can only be enabled when the [I/O Detection] mode is applied. The system will repeat
recognition until the vehicle leaves the I/O sensor or the recognition result is “Registered” or at least “Visitors”.
This function will increase the recognition rate. For the system used for a car park for registered car, it is
suggested to set to “Registered”. For the non-registered usage like public car park, it is suggested to set to
“Registered” plus “Visitors”.
Figure 3-53
44