GV-LPR License Plate Recognition User Manual - GeoVision

Chapter 1 Hardware Installation
2. If the computer has a reset switch, the switch’s jumper wire should already be connected to the
motherboard’s reset jumper pins. Remove the switch wire from the motherboard and connect it to the
reset jumper pins on the card.
1.2 Install Dongle
It is required to install a dongle before you run GV-LPR. Two types of dongles are provided for different
installations.
1.2.1 With a GV Video Capture Card on GV-LPR System
The dongle is a 4.7 cm x 2 cm x 0.9 cm blue color USB plug-in key. It can be used for the USB port that
supports USB 1.1 or above. Please plug in the dongle in the USB port before lunching the GV-LPR system.
The dongle for 1, 2, 4, 6 and 8 lanes are different. Without the dongle the system cannot be run.
Figure 1-5
1.2.2 Without a GV Video Capture Card on GV-LPR System
You can run GV-LPR system without a GV Video Capture Card. Before running the system, you must insert a
the required black dongle and install the dongle driver. For details about installing the driver, see 1.2.3 Install
Driver.
Figure 1-6
1.2.3 Install Driver
If you run GV-LPR system without a GV Video Capture Card, you must insert a black dongle and install the
necessary driver. Follow these steps:
4