Reocor S - BIOTRONIK USA - News

60 General Description
Visual and Acoustic Signals
English
• During the self-test after switching on Reocor S,
all LEDs light up and brief acoustic signals can be
heard. The self-test is finished after a few seconds.
• If the self-test does not find any errors, the LEDs
and warning signals turn off.
• When the self-test finds a defect, all LEDs flash
continuously and warning signals sound.
• A required battery replacement is indicated by the
flashing red Low battery LED.
• The Sense (green) LED signals sensing of a P wave
or R wave.
• The Pace (yellow) LED signals pulse delivery.
• The LEDs and acoustic signals also provide the
following warnings during operation:
Warning Meaning Error correction
Acoustic signal for
two seconds
Fast sequence of
sounds
Acoustic signal and
flashing of the Pace
and Sense LEDs
Low battery LED
flashes.
A pulse amplitude of 1 V or
a rate of 180 ppm is programmed.
Impedance outside of the
permissible range
High rate protection has
been triggered;
self-test failed.
Check whether the set
values are suitable for
the patient.
Check whether all connectors
are securely
plugged in.
Check whether the
leads have the desired
position.
Turn the device off and
return it to BIOTRONIK.
ERI has been reached. Replace the battery;
and about 36 hours a) of
a) When using the battery type MN 1604 Duracell ® , Procell ®
service time remain.