Reocor S - BIOTRONIK USA - News

85 Technical Data
Fixed parameters
High rate protection
1 … 180 ppm
181 … 250 ppm
Pulse waveform
286 ms ± 10%
214 ms ± 10%
Asymmetric, biphasic
286 ms = 210 ppm, does not
apply for Burst
214 ms = 280 ppm, does not
apply for Burst
Lead impedance monitoring
Acoustic warning Above 2000 15%, at 5 V amplitude
Lead connection Touch-proof 2-mm connector ports;
Redel port, 6-pin via Redel adapter
English
Electrical data/battery
Battery
Polarity
Inverse-polarity
protection
Power consumption
Service time with new
battery b)
End of service (EOS)
Remaining service time
after ERI signal b)
Behavior during
battery exchange
• Alkaline-manganese type: IEC 6LR61 / ANSI 1604A
• 9 V leak-proof
• E.g. MN1604 Duracell ® Procell ®a)
Cathodic
None: Polarity is irrelevant
Typically 1 mA (70 ppm, 5.0 V, 500 )
• 600 h (-10%) at 20°C (± 2°C)
• At: 70 ppm, 5 V, mode VVI, 500 ohm
• Until: ERI signal (EOS warning)
Flashing “Low battery” LED
• 36 hours
• At: 70 ppm, 5 V, mode VVI, 500 ohm
• Device remains ready for use for at least 30 s when the
battery is removed.
• The set Mode is retained.
a) Registered trademark of Duracell Inc., Bethel, CT 06801
b) When using the battery type MN 1604 Duracell ® , Procell ®
Ambient conditions
Temperature range for operation
Temperature range for storage
Relative humidity
Atmospheric pressure
Noise level
+10°C … +40°C
0°C … +50°C
30% … 75%, non-condensing
700 hPa … 1060 hPa
50 dB