【User Manual】 Lite-Puter Enterprise Co., Ltd. - Notape

ISO 9001 CERTIFIED www.liteputer.com.tw
[ SELECT SHOW TO RUN ]
Off the show
Press【SHOW】→ →press show function to turn off show mode (show1
is out, but only turn off the intensity ).
Press【SHOW】→ Come back the show1
Press show2,scene2 in the same time Come in those together , it will change by itself
Call sever shows come in together
Press and hold show1,add press show3 There are show1,show2,show3 and scene1 on stage
* Scene do not have to run in show mode
5-11-1 Pause to a show and scene
Pause the show
Put the pitch fader to half way in the fader. During the show those two fade have to set this for
Put the range fader to half way in the fader. the default setting in this control.
In the home page
[ SELECT SHOW TO RUN ]
In the home page
Press Bank 2
Select bank 2 , →press show function→run the
Press【SHOW】→ Press【SHOW1】
show1 .
→Press【MACRO】
Pause the show
→【►】
→Go next step
→【w】
→Go back previous.
→Press【MACRO】 Release the pause of the show.
5-11-2 changing the Rate of a show
In the home page
[ SELECT SHOW TO RUN ]
Press Bank 2
Press【SHOW】→ Press SHOW 1, SCENE 1
Slide the pitch & range fader up
Slide the pitch & range fader down
Reduce the speed of the show and the scene
In the home page
Select bank 2 , →press show function→run the
show1 .
Slide up will going up the speed.
Slide down will slow down the speed.
* Pitch is fade time ,Range is wait time 。You can try to adjust them together or
separate ,when the music is change you do not have time to editor the timing.
89
Lite-Puter
CX-18 [EUM-D]