Dragon NaturallySpeaking 12 Administrator Guide - Nuance

Dragon 12 Administrator Guide
Configuring Local or On-Demand
Install of Vocabularies/Text-to-
Speech (Optional)
172
This section describes how to enable Roaming User Profiles in a command line installation and is
a continuation of Installation using the Dragon command line.
Note: You take the following actions on the client computer where you want to install Dragon,
not on the computer where you carry out the initial installation.
Installing only particular vocabularies locally,
others on-demand
When you install Dragon on a client computer as outlined in Installation using the Dragon command
line, by default you install all the available vocabularies locally.
If you do not want all of those vocabularies to be installed locally, but to instead have them
installed only if/when an end-user attempts to deploy a particular vocabulary, you can indicate
that fact on the installation command line by adding the ADDLOCAL option and setting it to the
names of the vocabularies to install locally.
For example, say you want to do a partial installation of Dragon and you only want to install the
General vocabulary. You set ADDLOCAL to NatSpeak, ENUGeneral, and the command line
would appear as follows (NatSpeak must be in the setting of ADDLOCAL, unless you set ADD-
LOCAL to ALL; otherwise, the installation fails):
setup.exe /s /v"SERIALNUMBER=#####-###-####-####-##
DEFAULTSINI=\"C:\\nsdefaults.ini\"
INSTALLDIR=\"C:\\Dragon12\" PRODUCTUPDATEFLAG=-1
REBOOT=ReallySuppress ADDLOCAL=NatSpeak,ENUGeneral
/L*v C:\Logs\logfile.log /qn"
Note: There must not be any spaces between the arguments specified for ADDLOCAL.
If you want other vocabularies to be available, you set ADDLOCAL to ALL and set the ADVER-
TISE property to a list of additional vocabularies. The command line might look like the following:
setup.exe /s /v"SERIALNUMBER=#####-###-####-####-##
DEFAULTSINI=\"C:\\nsdefaults.ini\"
INSTALLDIR=\"C:\\Dragon12\"
PRODUCTUPDATEFLAG=-1 REBOOT=ReallySuppress ADDLOCAL=ALL
ADVERTISE=
/L*v C:\Logs\logfile.log /qn"
Separate the features/vocabularies for ADDLOCAL with commas, but do not put spaces in the
list. The names you must use for the vocabularies consist of a prefix for the language, then the