Dragon NaturallySpeaking 12 Administrator Guide - Nuance

Chapter 7: Using Dragon on Windows Server 2008 R2 or Windows 7 Ultimate Server
Installing Dragon software on the
server and the client computer
To enable audio redirection through a remote desktop connection, and allow users to connect and
use Dragon on Windows Server 2008 R2 or Windows 7 Ultimate Server, you install software on
Windows servers and on Dragon workstations. You can expect to spend around thirty minutes
installing and configuring the required software.
Perform the following steps:
1. Install Dragon on Windows Server 2008 R2 or Windows 7 Ultimate Server. See Installing
Dragon on a single computer for more information.
2. To use a smartphone device as a microphone- Configure the Dragon Remote Microphone application
on your iPhone to communicate with Dragon.Installing the Dragon Client for Remote
Desktop software and using the Audio Setup wizard is not required for smartphones.
or
To use a non-smartphone device as a microphone - On each client computer that will connect
to Dragon on the server, install the Dragon Client For Remote Desktop on the client computer:
1. Insert your Dragon NaturallySpeaking DVD in your local computer's DVD drive.
2. In the Dragon Client For Remote Desktop folder, run setup.exe and follow the
steps to install the software.The program group "Dragon Client For Remote Desktop"
appears in your Windows program folders available from the Windows Start
menu.
Note: If you are installing Dragon Client for Remote Desktop using the MSI Windows
Installer, run dragonclientinstaller.msi.
3. Connect the microphone that you will use to dictate with Dragon.
4. If your computer has multiple audio sources, make sure that your microphone is
set as the Default recording.
5. From the Dragon Client for Remote Desktop program group, run the Audio
Setup Wizard to configure your microphone.
Note: To use a smartphone or other supported wireless device as a remote microphone,
do not use the Audio Setup wizard. See Set up a smart device as a microphone
Dragon Client For Remote Desktop components
The Dragon Client For Remote Desktop installation consists of two components that you install
on the client computer:
n Audio Setup Wizard: a stand-alone application that provides a way to check that
your microphone sound levels and signal quality are suitable for using Dragon
NaturallySpeaking with a remote desktop connection.
n PMIIControl.exe - the Powermic II Button Control application: a stand-alone
application that provides a way to customize the buttons on the PowerMic II. The
buttons can be used with Dragon NaturallySpeaking while working across the
285