DocuPrint M205 b/M205 f/M205 fw User Guide - Fuji Xerox Printers

•WPS-PBC
NOTE:
• WPS-PBC is a method to authenticate and register devices required for wireless configuration, by pressing
the button provided on the access point via wireless routers, and then performing WPS-PBC setting on the
operator panel. This setting is available only when the access point supports WPS.
1 On the operator panel, press the (System) button.
2 Select Admin Menu, and then press the button.
3 Select Network, and then press the button.
4 Select Wireless Setup, and then press the button.
5 Select WPS, and then press the button.
6 Select Push Button Control, and then press the button.
7 Select Yes, and then press the button.
8 Press and hold the WPS button on the access point.
9 Wait a few minutes until the printer restarts to establish the wireless network.
10 Print a System Settings page from the operator panel.
See "Printing a System Settings Page" on page 182.
11 Confirm that "Link Quality" is shown as "Good", "Acceptable" or "Low" on the report.
NOTE:
• When "Link Quality" is "No Reception", check if the wireless settings are correctly configured.
131 Printer Connection and Software Installation