The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>The</strong> <strong>Turbo</strong> Air <strong>3000</strong> <strong>Centrifugal</strong> <strong>Compressor</strong> Operator’s Manual<br />
A—34<br />
Pre-Startup Inspection Checklist continued…<br />
Electrical Interface<br />
3 Earth ground installed<br />
3 All applicable codes met<br />
3 Motors wired according to manufacturer’s instructions<br />
3 Motor controllers and starters wired according to manufacturer’s instructions<br />
3 Control panel wired properly<br />
Shaft Freedom<br />
3 Motor shaft freely moved when turned by hand<br />
3 <strong>Compressor</strong> shaft freely moved when turned by hand<br />
Main Drive Motor<br />
3 Motor bearings properly lubricated<br />
3 Motor rotation direction checked<br />
3 Main drive coupling properly installed and lubricated<br />
Lubrication System<br />
3 Reservoir filled with correct type and quantity of oil<br />
3 Reservoir vent filter trap filled with oil<br />
3 Optional oil reservoir heater thermostat set to 100° F (40° C)<br />
3 Pump motor bearings properly greased<br />
3 Oil pump rotation checked<br />
3 Pump operated for at least 2 hours to completely flush system<br />
3 New oil filter element installed after system is flushed<br />
3 No leaks detected when pump motor is operating<br />
Control System<br />
3 Air pressure transducers properly connected<br />
3 Initialization checked<br />
3 Setpoints checked<br />
3 Inlet guide vane assembly operation checked<br />
3 Bypass or Modulating Blow-off Valve operation checked<br />
3 Current sensor checked<br />
3 Probe gaps checked<br />
Table A—2. <strong>The</strong> Prestart Inspection Checklist
Change language