The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Initial Start-up Checklist<br />
Installation<br />
<strong>The</strong> instructions given here provide a sequence of steps to follow during initial compressor operation.<br />
WARNING:<br />
Do not attempt to start up the <strong>Turbo</strong> Air <strong>Centrifugal</strong> <strong>Compressor</strong> until after a CTCauthorized<br />
service representative has fully inspected and approved the compressor<br />
installation. Cooper <strong>Turbo</strong>compressor recommends that a trained and authorized service<br />
representative perform the initial startup procedure.<br />
Before Applying Power<br />
Check the following before turning power on:<br />
c Verify the manual block valve is closed.<br />
c Check the location of the system pressure transducer.<br />
c Check wiring for correctness, loose wires.<br />
c Verify earth grounding.<br />
c Check motor starter interface wiring from Vantage.<br />
c Remove oil pump opto and motor circuit optos.<br />
c Check Main motor and auxiliary oil pump overload settings.<br />
c Check the supplied panel power.<br />
Powered Pre-Start Checks<br />
Apply power and perform the following checks before starting the compressor:<br />
c Turn off access codes.<br />
c Verify the configuration in the Vantage matches the configuration checked before<br />
traveling to the job site and make any changes required.<br />
c Check vibration probe gap.<br />
c Verify the instrumentation (wiring & monitoring points).<br />
c Verify valve operation.<br />
c Verify the Vantage Maximum Motor Current setting equals the motor FLA.<br />
c Turn-on oil reservoir vent ejector.<br />
c Verify oil pump operation.<br />
c Verify start-up status.<br />
c Bump main motor verify rotation & re-couple.<br />
c Turn on coolant.<br />
A—39