The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
The Turbo Air® 3000 Centrifugal Compressor Compressor Handbook
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Routine Operation<br />
Adjusting the System Pressure Set Point<br />
During normal operation, it may become necessary to make small adjustments to the System<br />
Pressure Set Point in order to alter the operating characteristic of the compressor. <strong>The</strong> example here<br />
shows a System Pressure that has been set at 98.0 psi.<br />
CAUTION:<br />
DO NOT operate the compressor at pressures greater than the nameplate rating.<br />
Doing so could result in equipment damage or personal injury.<br />
Adjust the System Pressure Set Point as follows:<br />
1. Press the Set Points key to display a list of set point selections.<br />
2. Press the Up or Down key as needed to highlight Operator .<br />
3. Press the Enter key to open the Operator screen. (Enter your Operator Access Code if<br />
prompted)<br />
Pressure Setpoint<br />
System Pressure Setpoint: 0 0 9 8.0<br />
System Pressure Offset: 3.0<br />
Maximum Motor Load (%): 100.0<br />
Use Enter key<br />
to move cursor<br />
to the right<br />
4. Use the Up or Down key to move the cursor to the value you want to change.<br />
5. Press Enter to move the cursor right to the digit you want to change.<br />
6. Press the Increase or Decrease key to change the value of that digit.<br />
7. Press Enter to move to continue moving through each digit, changing the value of digits<br />
only where necessary. (Back moves the cursor to the left.)<br />
8. On completion press Enter to return to the Set Points selection screen.<br />
4—7