HyperWorks 12.0 Release Notes

SIMPACK Interface
Allow Craig-Chang Super Elements in Residual Run Using
AMLS/AMSES
Time Varying W3 and W4 for Transient Response Analysis
Static Loads Can Now be Applied Dynamically for Transient
Analysis
Modal Participation Ratio Output
AUTOSPC for AMLS Solver Interface
SET Data Specifications for Rigid Element Output on the
MODEL Data
Modal Stress Data Can be Exported Using PARAM,LMSOUT
Element FORCE Results are Available for CBUSH, CELASi,
CDAMP, and CVISC Elements in Transient Response Analysis
Element FORCE Results are Available for CBUSH, CELASi,
CDAMP, and CVISC Elements in Frequency Response
Analysis
Element FORCE Results are Output From Eigenvalue Analysis
Element Strain Energy (ESE) is Now Written to the .op2 File
Element Strain Energy (ESE) for Frequency Response is Now
Written to the .pch File
Element Energies (ESE/EKE/EDE) for DMIG (CMS SE)
Elements are Now Written to the .out File
MPCFORCE Output is Now Available from Modal Frequency
Response Analysis
A File to Allow Optimization of CMS Super Elements Can be
Generated
Sets of RIGID Elements Can Now be Specified with the Bulk
Data SET Data
New Parameters
New Subcase Information Entries
Enhanced Subcase Information Entries
New I/O Option Entries
New Bulk Data Entries
Enhanced I/O Option Entries
Enhanced Solution Control Entries
Enhanced Bulk Data Entries
Resolved Issues
12.0 - RADIOSS for Kinematic Analysis (Bulk Data Format)
Ply-based Composite Definition Can Now be Used in MBD
Analysis
CB and CC Flexbody Generation Time Reduced