HyperWorks 12.0 Release Notes

Result Initializer
This tool enables to compute the initial stresses/plastic strains and thicknesses using a one-step
approach. So INITIAL_STRESS_SHELL/ELEMENT_SHELL_THICKNESS cards are created. Needs to be
installed with a HM11.101 version minimum.
A part from this tool it is now possible to display initial results from forming loaded with the model.
*MAT_
MAT_113, MAT_131,MAT_132, MAT_173
Model Checker
Rigid Body defined on Rigid body node ( MAT_RIGID, Extra_node, NRB, Generalized_weld, etc.)
In Extra_node, PID or NID/NSID is Zero
In Extra_node, PART is not Rigid
Joint used non rigid body nodes
Joint is not connected to any parts
-*MAT and/or *SECTION not referred by PART
Double(same) ID in table and curve
Number of curve is not same as one defined by table
Same part are defined in slave and master in face to face contact
Too many lines in *SET_SHELL_GENERAL, *SET_SEGMENT_GENERAL -> Warning in case of more than
100
Check double Id for every type of entity which requires an Id
Slave set of *CONTACT as null should create a error.
*CONSTRAINED_
*ALE
*CONSTRAINED_TIED_NODES_FAILURE, *CONSTRAINED_LAGRANGE_IN_SOLID
*ALE_FSI_PROJECTION
*BOUNDARY
BOUNDARY_NON_REFLECTING
*ELEMENT
New panel for creating elements (*ELEMENT_...) including the non-connectivity fields
Back to top