HyperWorks 12.0 Release Notes

hm_ce_checklinentities
The command hm_ce_checklinentities works also for assembly names now.
Long Seam Connectors
For some very long seam connectors the link detection worked wrong and some obvious links weren’t
detected. This issue has been resolved and also the limitation for the maximum number of links, which
can be stored on a seam connector has been removed.
Slightly Curved Holes
In a few cases slightly curved holes weren’t accepted as true holes, which caused failed connectors.
This issue has been resolved.
Back to top
11.0.120 Release Notes - Geometry
New Features
• New option for choosing stitching mode when creating surfaces.
• Added thickness based stitch tol option for midsurfacing.
Resolved Issues
• Continued robustness and accuracy improvements for surface and solid editing.
• Continued robustness and accuracy improvements for midsurface generation.
• Continued robustness and accuracy improvements for defeaturing operations.
Back to top
11.0.120 Release Notes - HyperBeam
Add/Delete Vertex for Shell and Solid Sections
This mode is accessed by pressing the second to last button in the toolbar. This button is only active
for shell and solid beam sections.
Clicking this button launches into add and delete vertex mode.
In this mode, left clicking on or near any part (for a shell) or perimeter (for a solid) will create a new
vertex on the nearest part or perimeter. The part or perimeter will be diverted to now run through
the new vertex. If a clicked point is nearer to the end of a part than a segment of it, the part will be
extended.
In this mode, right clicking any vertex will delete the vertex.