Complete Material Standards Manual - Gainesville Regional Utilities

Valve, Plug, MJ x MJ, Eccentric, Direct Actuator
Material Item Approved for Use In:
Water System:
Wastewater System:
Reclaimed Water System:
Approved Manufacturers:
Manufacturer's Name: Model/Series #:
Clow Valve Company M5413
DeZurik 118-MJ
Henry Pratt Company
Milliken Valve Company 600
Material Description:
Plug valve shall be non-lubricated, eccentric
type with a minimum port opening of 80% suitable
for use in domestic wastewater systems. Plug
valve shall have an iron body, a welded nickel
seat, fully elastomeric (nitrile) encapsulated
iron plug, direct actuator with 2" square
operating nut, mechanical joint ends, rated for
150 psi working pressure, and fusion bonded
epoxy coating on interior (min.12 mil thickness)
and exterior surfaces.
Application:
For use in pressurized wastewater systems. 8"
round port also available - see sheet V-43.00.
See Appendix B for Installation Instructions
Pictures are for Illustrative Purposes Only
GRU Stock Information:
VALVE, PLUG
Stock Number Stock Description
000148806 4"
000148857 6"
000148903 8"
'For GRU use only: An X indicates item is stockless
ANSI A21.11 - MJ Ends
National Standards:
ASTM A126 - Iron Body (Class B)
See Appendix A for Full Description of Standards
Water, Wastewater and Reclaimed Water
Material Standards
V-43.40
6/10/2009