WYNN 7.0 User Guide - Freedom Scientific

Multi-user Logins
156
If another user wants to log in without quitting WYNN:
1. Choose Log Off from the File menu or click on the
name in the upper right corner.
2. A confirmation message appears. Click Yes.
3. The user can then log in, as previously described, and begin using
WYNN.
Note: If only one user will be using WYNN on this computer, you can skip the
log in process. To do this, choose Enable Multi-User Logins from the
File menu. Enable Multi-User Logins should be unchecked. The next
time you start WYNN, you will not be asked to log in. Choose this
command again to re-enable multi-user logins.
Device Selection
Note: WYNN automatically detects the camera and scanner drivers that are
installed on your computer, and selects one to use as the default. The
first time you acquire a document; the software displays a message
asking you to confirm the acquisition device selection. If you want to
change the device, do the following.
1. From the Advanced menu, choose Device Selection.
2. In the Acquisition Source box, select Scanner or PEARL Camera.
3. If you select Scanner as the acquisition source, select a scanner from
the Device box.
4. If necessary, select Properties to fine tune device settings.
5. Click OK to save device selection and close the dialog box, or Cancel
to close without saving changes.