WYNN 7.0 User Guide - Freedom Scientific

18
3. When prompted,
Choose Network WYNN installation
Choose a destination folder for Network WYNN. The default folder
is C:\WYNNNet. If you want to install it in a different folder, choose
Browse and select a new folder. Choose Next to continue with the
installation.
Choose a location for users to share their documents and settings.
The default document storage folder is C:\WYNNNet\Users. This
location must be shared so that all users can access it. Make sure
the storage location is shared and then select Next to continue.
Note: The installation wizard can automatically share this folder. It will have
Full Control permission for the Everyone group during installation and
then will be demoted to Read Only permission for the Everyone group
once installation is finished. Choose Yes to create this share or No to
continue.
4. When installation is complete, you can then set permissions for the
folders referenced in the next section. Once that is complete, you can
install WYNN Network Client on the workstations.
Refer to page 27 for WYNN client installation procedures.
During installation, several new folders and subfolders are created on
the server (see page 235). For a list of permissions assigned to these
folders, see User Permissions on page 233.
Configuring User Groups and Folder Permissions
Users must be able to access certain folders to use Network WYNN. You can
create one user group and set the access for that group, or you can create
many users and then set the folder access for each user.
Creating a User Group
Create a WYNN user group to easily add students who will use the WYNN
application. You can allow individual users to access the WYNN folders, but
you will have to set folder permissions for each user. If you create a group, you
only set folder permissions once for the group.