WYNN 7.0 User Guide - Freedom Scientific

- this portion of the argument specifies
the installers which will receive the command. Each of the Installer strings
should correspond to a section name in Settings.ini.
- the command to append to each of the specified installer's
command-line. If you wish to passthrough a command that includes the
characters /, - or # you must use the following escape sequences:
Sequence String
#0 #
#1 -
#2 /
Note: All occurrences of # in are interpreted as the beginning of
an escape sequence. All instances of # and the character which
follows the # will be replaced if a matching string can be found. If no
corresponding string can be found then the # and the character
following it will be removed.
For example, the sequence ## in would be removed
whereas #0 would be replaced with #.
Example:
c:\Package.exe /passthru AnInstaller,AnotherInstaller@#2l
Assume that the following is the Settings.ini from the above package.exe.
---Begin Settings.ini---
[default]
PreInstall = AnotherInstaller|AThirdInstaller
MainInstall = AnInstaller
[AnInstaller]
255