PPC-5190 User Manual - iEi
PPC-5190 User Manual - iEi
PPC-5190 User Manual - iEi
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>PPC</strong>-<strong>5190</strong> Flat Panel PC<br />
Page 53<br />
3.6 HDD, FDD and CD Drive Installation<br />
3.6.1 HDD Installation<br />
To install a HDD, please follow the steps below:<br />
Step 1: Remove the back cover (Section 3.5.1).<br />
Step 2: The HDD bracket is attached to the elevated platform by four retention screws.<br />
Remove the four retention screws from the elevated platform (Figure 3-2).<br />
Figure 3-2: HDD Retention Screws<br />
Step 3: Attach the HDD bracket to the HDD. To do this, align the four retention screw<br />
holes in both side of HDD bracket with the retention screw holes on the side of<br />
the HDD. Insert two retention screws into the bracket on both sides of the HDD.<br />
Step 4: Install the HDD into the <strong>PPC</strong>-<strong>5190</strong> by aligning the retention screw holes in the<br />
base of the HDD bracket with the retention screw holes on the elevated platform.<br />
Insert the four retention screws into the base of the HDD bracket.<br />
Step 5: Connect the IDE/SATA cable from the IDE/SATA connector on the motherboard<br />
to the rear of HDD.Step 0:
Change language