Council Minutes 21 January 2008 - Waratah-Wynyard Council

Planning Authority Reports
18. The provision of an 18 metre wide road reservation, suitably
widened to 25 metres to accommodate a vehicular turning
area, with lot boundaries splayed where necessary and shown
as road on the final plan lodged for sealing. Alternative
termination treatments will be considered.
19. The construction of an asphalt sealed, compacted crushed rock
pavement, designed in accordance with Austroads pavement
design guidelines, with a minimum pavement thickness of 250
mm plus a 30 mm asphalt seal, incorporating concrete kerb and
channelling and footpaths, all to the satisfaction of the Director
Engineering Services and in accordance with Standard
Drawing SD1001.
20. Pavement widths of the internal road to be provided are: 8.0
metres measured lip of kerb to lip of kerb and 6.0 metres
surface measured lip of kerb to lip of kerb for the courts.
21. The road intersections, both internally, and with the Council
road network, are to be assessed in regard to the various
requirements of the Austroads publication “Guide to traffic
engineering practice – part 5 Intersections at grade.
Deficiencies and traffic management issues identified are to be
addressed as part of the road design process.
22. York Street is to be constructed and sealed from the north
western interface with the sealed section of York Street to a
point 10 metres past the entry road in to the subdivision. The
road pavement is to be designed in accordance with the
Austroads pavement design guidelines and shall have an
asphalt surface of not less than 30mm compacted depth of
asphalt. The width of the road shall be 8.0 metres measured lip
of kerb to lip of kerb. Kerb and channelling is to be
constructed along the western side of York Street, from the
internal access road to the northern boundary.
23. Hill Street is to be constructed and sealed from the internal
access road to Inglis Street. The road pavement is to be
designed in accordance with the Austroads pavement design
guidelines and shall have an asphalt surface of not less than
30mm compacted depth of asphalt. The width of the road shall
be 8.0 metres measured lip of kerb to lip of kerb. Kerb and
channelling is to be constructed along the northern side of Hill
Street, from the internal access road to the eastern boundary
with Inglis Street.
Waratah-Wynyard Council – Ordinary Meeting Minutes – 21 January 2008 Page 43