digital video camera gr-dvx707 gr-dvx507 gr-dvx407 gr-dvx400 - JVC
digital video camera gr-dvx707 gr-dvx507 gr-dvx407 gr-dvx400 - JVC
digital video camera gr-dvx707 gr-dvx507 gr-dvx407 gr-dvx400 - JVC
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
VIDEO RECORDING<br />
Basic Recording<br />
NOTE:<br />
Before continuing, perform the procedures listed<br />
below:<br />
● Power ( pg. 10)<br />
● Loading A Cassette ( pg. 16)<br />
● Remove the lens cap ( pg. 7)<br />
POWER Lamp<br />
VIDEO/MEMORY Switch<br />
(GR-DVX707/507 only)<br />
EN 19<br />
5 To stop recording, press the Recording Start/Stop<br />
Button again. The camcorder re-enters the<br />
Record-Standby mode.<br />
Tape Remaining Time<br />
Approximate tape remaining time appears on the<br />
display. “– – min” means the camcorder is<br />
calculating the remaining time. When the remaining<br />
time reaches 2 minutes, the indication starts<br />
blinking.<br />
25 min<br />
Recording Start/<br />
Stop Button<br />
Power Switch<br />
PLAY<br />
OFF<br />
A<br />
M<br />
min 90 min 89 min 3 min<br />
(Now calculating)<br />
0 min 1 min 2 min<br />
(Blinking) (Blinking) (Blinking)<br />
MENU Wheel<br />
Tally Lamp<br />
Lock Button<br />
1 Set the VIDEO/MEMORY Switch to “VIDEO”.<br />
(GR-DVX707/507 only)<br />
2 Set the Power Switch to “A” or “M” while<br />
pressing down the Lock Button located on the<br />
switch.<br />
3 Open the LCD monitor fully, or pull out the<br />
viewfinder fully.<br />
● The POWER Lamp lights and the camcorder<br />
enters the Record-Standby mode. “PAUSE” is<br />
displayed.<br />
4 To start recording, press the Recording Start/Stop<br />
Button. The Tally Lamp lights and “T REC”<br />
appears on the display while recording is in<br />
pro<strong>gr</strong>ess.<br />
NOTES:<br />
● The image will not appear simultaneously on the<br />
LCD monitor and the viewfinder.<br />
● If the Record-Standby mode continues for<br />
5 minutes, the camcorder’s power shuts off<br />
automatically. To turn the camcorder on again,<br />
push back and pull out the viewfinder again or<br />
close and re-open the LCD monitor.<br />
● LCD monitor/viewfinder indications:<br />
• When power is supplied from a battery: the<br />
“ ” battery indicator is displayed.<br />
( pg. 100)<br />
• When power is supplied from an AC outlet: the<br />
“ ” battery indicator does not appear.<br />
● When a blank portion is left between recorded<br />
scenes on the tape, the time code is interrupted<br />
and errors may occur when editing the tape. To<br />
avoid this, refer to “Recording From The Middle<br />
Of A Tape” ( pg. 21).<br />
● To turn the Tally Lamp or beep sounds off,<br />
pg. 38, 48.<br />
● To record in LP (Long Play) mode, pg. 38, 44.<br />
● For other notes, pg. 81.