digital video camera gr-dvx707 gr-dvx507 gr-dvx407 gr-dvx400 - JVC

72 EN
USING THE REMOTE CONTROL UNIT (cont.)
Insert Editing
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
Remote sensor
4 Press START/STOP to begin editing.
● Confirm the insert at the time code you
checked in step 1.
● To pause editing, press START/STOP. Press it
again to resume editing.
5 To end Insert Editing, press START/STOP, then
STOP (8).
NOTES:
● Program AE with special effects ( pg. 38, 42)
can be used to spice up the scenes being edited
during Insert Editing.
● During Insert Editing, the date and time
information changes.
● If you perform Insert Editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
● During Insert Editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, Insert Edting stops. ( pg. 100, 101)
START/STOP
REW
STOP
INSERT
PLAY
PAUSE
NOTES:
● Before performing the following steps, make sure
that “TIME CODE” is set to “ON”. ( pg. 38, 49)
● Insert Editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
● To perform Insert Editing while watching in the
television, make connections. ( pg. 24, 25)
1 Play back the tape, locate the Edit-Out point and
press PAUSE (9). Confirm the time code at this
point. ( pg. 38, 49)
2 Press REW (3) until the Edit-In point is located,
then press PAUSE (9).
3 Press and hold INSERT
(I) on the remote
control, then press
PAUSE (9). The “9I”
indicator and the Time
Code (min.:sec.)
appear and the
camcorder enters
Insert-Pause mode.
12:34
9I