download - Knoll

Morrison Network Desk System
brackets
Morrison
description type w d h pattern no. paint
Desk support light seal MN2-DD( ) $102.
Desk support to pedestal MN1-DP 15.
Flat brackets with machine screws 18D worksurface 3 1 /2 8 – MB3-F18M 31.
24D worksurface 3 1 /2 14 – MB3-F24M 34.
30/36D worksurface 3 1 /2 20 – MB3-F30M 38.
Single bridging bracket 18D worksurface 3 1 /2 10 5 1 /4 MB1-SB18(L/R) 78.
24D worksurface 3 1 /2 13 1 /2 5 1 /4 MB1-SB24(L/R) 93.
30D worksurface 3 1 /2 19 1 /2 5 1 /2 MB1-SB30(L/R) 99.
Dual bridging bracket 24D worksurfaces 3 3 /4 13 1 /2 4 MB1-DB24 159.
30D worksurfaces 3 3 /4 19 1 /2 5 1 /2 MB1-DB30 177.
Transitional support panel Stanchion adapter kit – – – MN2-RSAK 15.
Support panel 6 1 26 MN2-RDR( ) 279.
Worksurface Planning
Worksurface stiffener 54 worksurface 43 2 1 /2 1 MB1-WS54 104.
60 worksurface 49 2 1 /2 1 MB1-WS60 104.
66 worksurface 55 2 1 /2 1 MB1-WS66 104.
72 worksurface 61 2 1 /2 1 MB1-WS72 104.
Order Code
Example: MB1-SB24-L
MB1 Bracket
SB Type
24 Worksurface size
L Left
Specification Information
Specify paint finish for transitional
support panel and light seal.
All other brackets are black.
Specify single bridging bracket left
or right handed (left for conference
top on left when seated at
worksurface).
163
Application Notes
F-type flat brackets join
worksurfaces at the same height, in
desk or panel system application.
SB bridging brackets are used to
join desk supported worksurface to
1/2 round or teardrop, when
worksurface is not pedestal
supported. SB brackets may also be
used with transitional support panel
to join worksurface to teardrop or
1/2 round with vertical panel.
MB1-SB18(L/R) single bridging
bracket supports freestanding split
VDT with 24 returns; it should be
used on each side in combination
with 9 end panels MNZE09( ).
DB bridging bracket is used to join
adjacent desk supports and
worksurfaces.
For pedestal or end panel supported
worksurface to half-round or
teardrop, use flat brackets and
support column.
For clear access kneespace at
half-round with vertical panel, use
transitional support panel, single
bridging bracket, and support
column.
Desk support light seal wraps
around corner legs of adjacent desk
supports, and provides additional
lay-in cable.
Worksurface stiffeners may be used
to span distances over 48 without
pedestal support. (Use one size
smaller than worksurface width
when supporting one end with a
pedestal.) Specify the pattern
number which corresponds to the
width to be spanned, e.g.
MB1-WS54 enables a 3-ply MU1 or
LU1 worksurface to span 54.