download - Knoll

Panel Rigidizer Brackets, Coat Hooks and Reveal Fillers
Specifications
Dividends Horizon
Panel Rigidizer Brackets
Panel rigidizer brackets are used to reduce
panel connection flex where panel to
worksurface brackets cannot be used.
Panel rigidizer brackets are unnecessary if
a panel can be properly secured with the
use of a panel to worksurface bracket.
Rigidizer brackets are available for
inline (straight), 2-way (L), 3-way (T)
and 4-way (X) panel conditions.
High-low panel to post conditions cannot
accommodate the panel rigidizer brackets. Full
view panel frames without a topway cannot
accommodate a panel rigidizer bracket.
Carpet grippers are recommended for
use with panel rigidizer brackets.
Specify panel rigidizer brackets for
appropriate panel attachment condition.
height in a 90 degree application
height attached to a universal post.
height attached to a universal post.
Carpet Grippers
Carpet grippers should be specified to
increase rigidity of unsupported panel runs.
The carpet grippers snap onto leveling glides
to prevent panel runs from shifting on carpet.
The glides rotate in carpet grippers to permit
leveling. Available in black finish only.
Panel-Mounted Coat Hook
The Dividends Horizon panel-mounted coat
hook is made of extruded aluminum and is
available in an anodized black finish or matte
aluminum finish. The coat hook attaches to
any Dividends Horizon panel by connecting
over the top of the Dividends Horizon radius
plastic and metal panel top caps only.
Slotted Standard Coat Hook
Independent of the top cap, the slotted
standard coat hook attaches to the left or
right vertical slotted standard of any Dividends
Horizon panel. The die cast slotted standard
coat hook is available in any of the Knoll
Core paint finishes. The slotted standard coat
hook is sold in packages of ten and is not
compatible with laminate tiles or screens.
Panel Reveal Fillers
Panel reveal filler strips are used to cover
unused vertical panel slots. Panel reveal fillers
are designed to only be used with Legacy
post panel applications. Panel reveal fillers
should not be used with panel applications
that are using DP7 posts. Panel reveal
fillers are available in two thickness:
1 / 2" for panel-to-panel and panel
to end trim attachment.
1 / 4" for panel-to-post attachment.
Panel reveal fillers are offered in a 74"
length and are field cut to install into
any Dividends Horizon panel height.
To determine the correct amount of reveal
fillers to be specified, use the following
formulas: For panels and end trim-2 x the
number of straight panel connections plus
the number of panel end trims. For panel to
post connections, 4x the number of posts.
Panel Rigidizer Brackets
Carpet Gripper
Panel Reveal Fillers
Two-way "L"
Panel-Mounted Coat Hook
(for radius plastic and
metal trim only)
Inline (straight)
Three-way "T"
Slotted Standard Coat Hook Application
Slotted Standard Coat Hook
Four-way "X"
144