download - Knoll

Curvilinear Wave End Worksurfaces
Specifications
Dividends Horizon
Curvilinear Wave End Worksurfaces
Dividends Horizon curvilinear wave
end worksurfaces are primarily used
in panel-hung applications.
Available Sizes
Curvilinear wave end worksurfaces are handed
with one side deeper than the other.
Curvilinear Wave End Applications
36" to 48" wide wave ends are generally
used as worksurface returns attached
to curvilinear corners.
72" wide wave ends are used as primary
worksurfaces with returns attached at
the deep end.
Note: Only 18" and 24" deep returns can be
attached to 72" wide wave end worksurfaces.
Curvilinear Wave End Support
In applications where worksurface ends are
mounted perpendicular to panels, panel-toworksurface
brackets or a cantilever and a
panel-to-worksurface bracket can
be used as shown below.
mid-span cantilever support including applications
involving pedestal support at one end.
Pedestal Support Applications
Pedestals can be used as supports
in the following locations:
curvilinear wave end worksurfaces
Recommended Pedestal Depths
18" deep pedestals
a 18" or 24" deep pedestal
a 24" or 30" deep pedestal
a 30" deep pedestal
Note: When the pedestal depth is less
than the worksurface depth, a panel-toworksurface
bracket must be used in the rear
corner of the worksurface to the panel.
Freestanding Applications
Curvilinear wave end worksurfaces can be used
supported by pedestals and end units. The
most common application is a 72" wide wave
end worksurface with a single pedestal and
end unit attached to a freestanding return.
Curvilinear Wave End Worksurface
Curvilinear Wave End Applications
Pedestal Support Applications
**
Curvilinear Wave End
Curvilinear Wave End Worksurface Sizes
Pedestal on deep end of
curvilinear wave ends
Return
30"/18"D
18"/30"D
30"/24"D
36"/24"D
24"/30"D
24"/36"D
**
** Requires a return panel,
panel-mounted C-leg support,
open support leg, or a pedestal
with a panel-to-worksurface
bracket for support.
Pedestal on shallow end of
curvilinear wave ends
286