download - Knoll

Panel Mounted Worksurface Supports
Specifications
Dividends Horizon
Panel-Mounted C-Legs, Open Support
Legs, and Worksurface End Panels
Panel-mounted C-legs, open support legs, and
worksurface end panels provide panel-hung
worksurface support when the worksurface
width runs parallel to the panel run.
Primary panel-mounted support applications
include:
• Rectangular worksurface end support
for 24" and 30" depth worksurfaces
• Mid span worksurface support for 24" and
30" depth worksurfaces
• Corner and split top corner worksurface
support
• Support for heavier worksurface load
applications
• Shared support between two adjacent
worksurfaces
Note: 18" deep and 36" worksurface
may not be used with panel-mounted
C-leg worksurface support.
Construction
C-leg support:
• Support foot: die cast aluminum
• Support leg: extruded aluminum
• Mounting bracket: 3 / 16" steel plate
Open Support Leg:
• Vertical members: extruded aluminum
• Top plate and spanner bar: 0.025"
cold rolled steel
• Mounting brackets: 3 / 16" steel plate
Worksurface End Panel:
• Panel: 20 gauge steel
• Mounting brackets: 14 gauge steel
Note: Open support legs and worksurface end
panels are only available in Knoll Core finishes
Note: The shared open support leg is
designed for use where 2 panels meet. It
cannot be used on the end of a panel run.
Note: Worksurface end panels are for use
with panels only and are non-handed.
Panel-Mounted
C-Leg Support
Panel-Mounted C-Leg
Support (radiused foot)
Open Support Leg
Worksurface End Panel
314