download - Knoll

Cable Management
Specifications
Dividends Horizon
Base Raceway Cable Tray
Optional steel cable trays are available for
installations requiring the use of data and
communications cables within the base raceway.
The cable tray mounts between the panel feet.
Cable trays are field-installed and
accessible from either side of the base
raceway. A single sided base raceway
cable tray should be specified when
attaching to a tile-to-floor panel base.
Note: Cables should not be installed in
base raceways without cable trays.
Beltway Cable Tray
An optional cable tray is available for data and
communications cables within the beltway.
Beltway cable trays should be used when wires
are being routed horizontally from panel-topanel
at the beltway. The cable tray mounts
into slots located on the vertical panel frame.
Cable trays are 1 1 / 4" high, 1 5 / 16" deep
and are field-installed. Construction is
Note: Beltway cable trays can be installed
in monolithic panels to provide additional
mid span insert support when required.
Worksurface Cable Management Basket
Constructed of black finished steel wire, the
worksurface cable management basket mounts
to the underside of worksurfaces to provide
management of excess cords and cables. Once
installed, the cable management basket slides
forward to a position abutting the panel face
to allow the passage of cords and cables.
Specify by width available between
worksurface supports. Black finish.
Worksurface cable management baskets are
1 1 / 2" high, 3 1 / 2" deep and 19 1 / 2" to 41 1 / 2" wide.
Vertical Wire Pathway Grommet
An optional plastic grommet that snaps into the
vertical wire pathway on the horizontal panel
frame to separate cables from the panel frame.
Located in center of topway and base raceway.
Topway Cable Grommet
The primary location for cable management
for Dividends Horizon is in the topway. In order
to utilize the topway channel effectively, the
outside knockouts must be removed by using
pliers. When the knockouts are removed the
cables can be easily managed in the channel.
If required, a topway knockout grommet may
be installed inside of the topway channel. Four
grommets would be required per panel topway
Worksurface Cable Management Clip
An optional cable management clip. 3 / 4" x
1
/ 2" (internal dimension) plastic clip manages
cables on the underside of worksurfaces.
Data Shield
If separation of cabling and electrical wires is
required within the base raceway, a data shield
can be attached below a base raceway power
module at either end. Data shields are fieldinstalled.
The data shield should be used with
base raceway panels or tile to floor panels only.
Vertical Wire Pathway
Worksurface Cable
Management Clip
Base Raceway
Cable Tray
Beltway Cable Tray
Topway Cable
Grommet
Data Shield
Worksurface Cable
Management Basket
204