ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

More documents

Recommendations

Info

3-36 Chapter 3: 7401-2xxx/3xxx Hardware Installation 1. Secure the Wall Plate to the wall with lag screws (4) into the studs or with hardware of similar strength. The recommended viewing height for the terminal is 1.2 m (48 in.) from the floor to the center of the screen. Note: Drill a hole in the wall for the cables if you are mounting the power supply on the opposite side of the wall. Flush Mounting Bracket Wall Plate Cable Routing Cable Routing (through wall) 16684 2. Mount the Power Supply to the wall with screws (4). 3. Route all cables through the brackets and connect them to the terminal. 4. Install the Flush Mounting Bracket to the back of the terminal with screws (4). 5. Install the terminal to the Wall Plate. The bottom of the Flush Mounting Bracket has slots that mate to locking tabs on the Wall Plate. Secure the unit with the screw.
Chapter 3: 7401-2xxx/3xxx Hardware Installation 3-37 7401-9212 LCD No-Cabinet (12.1-inch) The 12.1‐inch LCD No‐Cabinet model is purchased by customers who design their own enclosures to meet their specific needs. This section provides information that must be considered when designing enclosures. Front View 18577 Back View Motion Sensor 18743
Page 1 and 2:
NCR NCR EasyPoint 7401 Release 2.5
Page 3 and 4:
i Safety Warnings Preface Audience
Page 5 and 6:
iii Grounding Instructions In the e
Page 7 and 8:
v Table of Contents Chapter 1: 7401
Page 9 and 10:
vii Compact Flash (Optional).......
Page 11 and 12:
ix Internal Speaker ...............
Page 13 and 14:
xi Calibration Using MicroTouch (Wi
Page 15 and 16:
xiii Setting Boot Options .........
Page 17 and 18:
xv NCR 7401‐21xx/31xx NT Operatin
Page 19 and 20:
xvii Revision Record Issue Date Rem
Page 21 and 22:
xix IEC & EN Laser Product Label CA
Page 23 and 24:
Chapter 1: 7401-2xxx/3xxx Product O
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67:
Page 70 and 71:
2-2 Chapter 2: 7401-4xxx Product Ov
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
2-10 Chapter 2: 7401-4xxx Product O
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89: 2-20 Chapter 2: 7401-4xxx Product O
Page 103 and 104: Chapter 3: 7401-2xxx/3xxx Hardware
Page 137: Chapter 3: 7401-2xxx/3xxx Hardware
Page 163 and 164: Chapter 4: 7401-4xxx Hardware Insta
Page 189 and 190:
Chapter 4: 7401-4xxx Hardware Insta
Page 191 and 192:
Page 193:
Page 196 and 197:
5-2 Chapter 5: Setup Entering Setup
Page 198 and 199:
5-4 Chapter 5: Setup Setting Passwo
Page 200 and 201:
5-6 Chapter 5: Setup Setting Memory
Page 202 and 203:
5-8 Chapter 5: Setup BIOS Default C
Page 204 and 205:
5-10 Chapter 5: Setup Memory Cache
Page 206 and 207:
5-12 Chapter 5: Setup System Temper
Page 208 and 209:
5-14 Chapter 5: Setup Continuous PO
Page 210 and 211:
5-16 Chapter 5: Setup Interrupts (7
Page 212 and 213:
5-18 Chapter 5: Setup BIOS Default
Page 214 and 215:
5-20 Chapter 5: Setup Cache Memory
Page 216 and 217:
5-22 Chapter 5: Setup System Temper
Page 218 and 219:
5-24 Chapter 5: Setup QuickBoot Mod
Page 220 and 221:
5-26 Chapter 5: Setup Interrupts (7
Page 222 and 223:
5-28 Chapter 5: Setup BIOS Default
Page 224 and 225:
5-30 Chapter 5: Setup Advanced Valu
Page 226 and 227:
5-32 Chapter 5: Setup Memory Map (7
Page 228 and 229:
6-2 Chapter 6: Operating System Rec
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
6-10 Chapter 6: Operating System Re
Page 238 and 239:
Page 240 and 241:
Page 242 and 243:
Page 244 and 245:
Page 246 and 247:
Page 248 and 249:
Page 250 and 251:
Page 252 and 253:
Page 254 and 255:
Page 256 and 257:
Page 258 and 259:
7-2 Chapter 7: BIOS Updating Proced
Page 260 and 261:
Page 262 and 263:
Page 264 and 265:
Page 266 and 267:
8-2 Chapter 8: NCR 7401 7890/7892 S
Page 268 and 269:
8-4 Chapter 8: NCR 7401 7890/7892 S
Page 270 and 271:
8-6 Chapter 8: NCR 7401 7890/7892 S
Page 272 and 273:
A-2 Appendix A: Cables Corporate ID
Page 274 and 275:
B-2 Appendix B: Feature Kits 2. Sel
Page 276 and 277:
B-4 Appendix B: Feature Kits Kit Nu
Page 278 and 279:
B-6 Appendix B: Feature Kits Kit Nu
Page 280 and 281:
Index-2 Setting boot options, 5‐6
Page 282 and 283:
Index-4 OS Recovery from a Larger D
show all

ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

Create successful ePaper yourself

Delete template?

Save as template?