ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

Chapter 4: 7401-4xxx Hardware Installation 4-19
To locate the 7401‐4xxx terminal so the edge of the Keyboard Tray
is even with the edge of the table top, locate the front edge of the
Table Top Mount 210 mm (8.25 in.) from the edge of the mounting
surface.
2. Drill pilot holes or through holes for the mounting screws (4) or
mounting bolts. Screws or bolts used for mounting the terminal are
not provided with the mount and must be purchased locally. The
holes in the mount are xx mm (xx in.) in diameter.
3. Drill the hole to route the cables out the bottom of the terminal, if
using that cable routing solution.
4. Secure the Table Top Mount to the mounting surface.
Note: When the front edge of the Table Top Mount is located away
from the edge of the mounting surface, it may be necessary to
remove the Motorized Card Reader, Keyboard, and Sliding Drawer
assembly before placing the terminal onto the mount to provide access
to the mounting screws. Refer to the “Accessing the Mounting
Screws” section below for details.
5. Lower the terminal onto the Mount aligning the locking pins (4) on
the bottom of the terminal with the slots in the mount.
Caution: Use care when lifting the terminal. The 7401‐4xxx
terminal weighs approximately 90 lbs. (40.8 kg).
6. Push the terminal to the back until the locating pins (2) in the back
of terminal are fully engaged into the holes in the mount.
7. Secure the terminal to the mount using the 8x32 screws (2).