ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

3-44 Chapter 3: 7401-2xxx/3xxx Hardware Installation
Installing the UPS
Refer to the User’s Manual delivered with the NCR 4055 UPS before
installing the UPS for use with the 7401.
To install the UPS with the 7401 connect the power cable and the LAN
cable from the 7401 to the UPS. Then connect the in‐house LAN cable
to the UPS, and the power cable on the UPS to the AC power outlet.
Note: If you are installing the K580/K590 Self Service Printer or the
Printer Spacer in a Pedestal Mount, the UPS must be installed first. See
7401‐K037 and 7401‐K052 Feature Kits for more information.
Installing the Power Mon II® Software
The Power Mon II® software is provided on CD‐ROM and may be
installed over a network or using an integrated or parallel CD‐ROM
drive. All operating system versions of the Power Mon software and
installation documentation are contained on the CD.
The Power Mon installation should auto start. If it doesn’t, browse the
CD for the operating system you are using and run Setup.exe for that
operating system. Follow the prompts to install the software.
Note: When you are prompted for Configuration Code, enter 7 to
identify the interface cable type.