ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

4-16 Chapter 4: 7401-4xxx Hardware Installation
ATTN/ERR (yellow)
Used with the buzzer to indicate the following conditions:
Status
Switch press
System warnings
System error
codes
Normal display
Indication
Short flash/beep when Switch F0‐F3 are pressed
Flashing/beeping to alert operator of low paper or
out of paper condition
Repeating sequence of coded flash/beep tones (used
during factory/depot repair)
Off
Panel Switches
The four momentary push button switches (F0‐F3) are used for manual
interaction with the printer.
F0/SELECT
Places the printer in On‐line or Off‐line (Test) mode. The READY LED
is off when the printer is in Test mode. The ATTN/ERR LED blinks and
the beep tone sounds every 14 seconds to indicate the printer is Offline.
F1/TEST
Alternately prints one of two test pages.
• One page is a short 85 mm (3.5 in.) page with that identifies the
printer and the printer manufacturer.
• The second page is a full 280 mm (11 in.) page with the same
information plus multiple lines of alphanumeric data scrolling
across the page.