ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

5-2 Chapter 5: Setup
Entering Setup Using a Keyboard
b) As instructed on the screen, touch the circle near the lower‐left
corner of the screen. For best results, press the screen near the
circle and then slide your finger onto the circle without raising
your finger from the screen.
c) Using the same method as above, touch the circle near the
upper‐right corner of the screen.
You should receive a Successful Calibration message and then the
PhoenixBIOS Setup Utility should come up.
d) Select the setup parameters by touching the controls at the
bottom of the screen.
1. Apply power to the terminal.
2. Press the F2 key when the message at the bottom of the screen
prompts you to do so. With Pentium III/Celeron terminals, you will
not see this prompt if the Boot‐Time Diagnostics Screen is disabled,
but you can still enter setup by pressing F2.
Note: Setup can also be entered from the Boot Menu that is
displayed when you press ESC during POST.