ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

More documents

Recommendations

Info

6-30 Chapter 6: Operating System Recovery 9. Select Local → Disk → From Image and press Enter. 10. The directory that Ghost is now looking in should be Z: (if not, switch to Z). Select the File name to load image from file (nnnnnnn.gho) and press Enter. 11. Select the Local destination drive and press Enter. 12. Set the sizes of the primary and secondary partitions as follows. O/S Primary Partition/ Format Secondary Partition Size DOS 2 GB/FAT16 2 GB/FAT16 Win95 2 GB/FAT16 Fill remainder as FAT 32 WinNT 2 GB/FAT16 Fill remainder as NTFS Win98 Single FAT 32 partition N/A Win2000 Single FAT 32 partition N/A WinXPe Single NTFS partition N/A In order to do this you may need to clear the amount from the second partition. 13. Press Enter. 14. If you are recovering from Win9x, it is likely that the second partition will be too small for FAT32. If so, a dialog is displayed Converting partition from FAT32 to FAT, proceed? Choose Yes. 15. At the next dialog box, Proceed with disk load? Destination drive will be permanently overwritten, Choose Yes to start the recovery process.
Chapter 7: BIOS Updating Procedures Introduction The terminalʹs BIOS can be updated using a parallel CD‐ROM drive and software available on bootable CD‐ROM media. The drivers necessary to run the CD‐ROM are temporarily installed during boot. This chapter describes this procedure. It is also possible to perform a BIOS update using a network connection. Refer to the NCR FitClient Software Userʹs Guide for information about that procedure. Crisis Recovery In the event the BIOS becomes corrupt, such as the result of a power failure during the BIOS Update procedure, you can use the method discussed later in this chapter in the BIOS Crisis Recovery section to recover the BIOS. Prerequisites The following are required on the <strong>7401</strong> in order to perform a BIOS update using a CD. • Bootable CD‐ROM drive − Integrated <strong>7401</strong>‐F058/F059 − External 2336‐K007 (Parallel CD‐ROM – Series 5 or Series 6) • The terminal BIOS must be 1.02.00.00 or greater. − MicroSolutions BackPack CD‐ROM Series 6 requires BIOS 2.1.1.1 or greater • Keyboard • NCR BIOS and BIOS Update Software (LPIN: A370‐0022‐0100)
Page 1 and 2:
NCR NCR EasyPoint 7401 Release 2.5
Page 3 and 4:
i Safety Warnings Preface Audience
Page 5 and 6:
iii Grounding Instructions In the e
Page 7 and 8:
v Table of Contents Chapter 1: 7401
Page 9 and 10:
vii Compact Flash (Optional).......
Page 11 and 12:
ix Internal Speaker ...............
Page 13 and 14:
xi Calibration Using MicroTouch (Wi
Page 15 and 16:
xiii Setting Boot Options .........
Page 17 and 18:
xv NCR 7401‐21xx/31xx NT Operatin
Page 19 and 20:
xvii Revision Record Issue Date Rem
Page 21 and 22:
xix IEC & EN Laser Product Label CA
Page 23 and 24:
Chapter 1: 7401-2xxx/3xxx Product O
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67:
Page 70 and 71:
2-2 Chapter 2: 7401-4xxx Product Ov
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
2-10 Chapter 2: 7401-4xxx Product O
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 103 and 104:
Chapter 3: 7401-2xxx/3xxx Hardware
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Chapter 4: 7401-4xxx Hardware Insta
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193:
Page 196 and 197:
5-2 Chapter 5: Setup Entering Setup
Page 198 and 199:
5-4 Chapter 5: Setup Setting Passwo
Page 200 and 201:
5-6 Chapter 5: Setup Setting Memory
Page 202 and 203:
5-8 Chapter 5: Setup BIOS Default C
Page 204 and 205:
5-10 Chapter 5: Setup Memory Cache
Page 206 and 207: 5-12 Chapter 5: Setup System Temper
Page 208 and 209: 5-14 Chapter 5: Setup Continuous PO
Page 210 and 211: 5-16 Chapter 5: Setup Interrupts (7
Page 212 and 213: 5-18 Chapter 5: Setup BIOS Default
Page 214 and 215: 5-20 Chapter 5: Setup Cache Memory
Page 216 and 217: 5-22 Chapter 5: Setup System Temper
Page 218 and 219: 5-24 Chapter 5: Setup QuickBoot Mod
Page 220 and 221: 5-26 Chapter 5: Setup Interrupts (7
Page 222 and 223: 5-28 Chapter 5: Setup BIOS Default
Page 224 and 225: 5-30 Chapter 5: Setup Advanced Valu
Page 226 and 227: 5-32 Chapter 5: Setup Memory Map (7
Page 228 and 229: 6-2 Chapter 6: Operating System Rec
Page 236 and 237: 6-10 Chapter 6: Operating System Re
Page 258 and 259: 7-2 Chapter 7: BIOS Updating Proced
Page 266 and 267: 8-2 Chapter 8: NCR 7401 7890/7892 S
Page 272 and 273: A-2 Appendix A: Cables Corporate ID
Page 274 and 275: B-2 Appendix B: Feature Kits 2. Sel
Page 276 and 277: B-4 Appendix B: Feature Kits Kit Nu
Page 278 and 279: B-6 Appendix B: Feature Kits Kit Nu
Page 280 and 281: Index-2 Setting boot options, 5‐6
Page 282 and 283: Index-4 OS Recovery from a Larger D
show all

ncr/doc/Kiosks/TechnicalManuals/7401_Kiosk_Har... - Alsys Data

Create successful ePaper yourself

Delete template?

Save as template?