MC52i AT Command Set

MC52i AT Command Set
8.9 AT^MONP
8.9 AT^MONP Monitor neighbor cells
The AT^MONP supplies information of up to six neighbor cells. There are two ways to retrieve the information:
once on request by using the execute command or automatically every seconds by using the write
command. To stop the periodic presentation type "AT" or "at".
Syntax
Test Command
AT^MONP=?
Response(s)
^MONP:(list of supported s)
OK
Exec Command
AT^MONP
Response(s)
See: Section 8.9.1, AT^MONP responses
OK
Write Command
AT^MONP=
Response(s)
See: Section 8.9.1, AT^MONP responses
OK
ERROR
+CME ERROR:
PIN ASC0 ASC1 MUX1 MUX2 MUX3 Charge Last
- + + + + + - - -
Parameter Description
(num)
Display period in seconds
1...254
Notes
• Due to the fact that not all necessary information of the neighbor cells can be decoded during a connection,
there are several constraints to be considered:
- Only neighbor cells that have already been visible in IDLE mode will be further updated, as long as they
are still included in the list.
- Though new neighbor cells can be added to the list (e.g. due to handover), their C1 and C2 parameters
cannot be displayed until the connection is released. In this case "-" will be presented for C1 and C2.
• To some extent, the cell monitoring command AT^SMONC covers the same parameters. The receiving level,
for example, can be queried with both commands. Yet the resulting values may be slightly different, even
though obtained over a time period of a few seconds. This is quite normal and nothing to worry about, as the
cell information is permanently updated.
• For compatibility with earlier products and to support legacy applications, any input character may be used to
stop the output in certain cases (depending on the settings of AT+IPR and AT+CMUX).
MC52i_ATC_V01.201 Page 184 of 551 4/16/10
Confidential / Released